REPOWER
BATTERY CHARGER
WITH AUTOMATIC DESULPHATION
Microprocessor
based electronic charger
with 7-stage charge controller and with unique and innovative automatic
desulphation technology to restore exhausted lead batteries that can no
longer be charged normally with standard battery
chargers.
THE
SULPHATION
In
the discharge phase in a lead battery, a chemical reaction of lead
sulfate production (PbSO4) occurs, resulting in an increase in the
density of the sulfuric acid electrolyte solution (H2SO4). Lead sulfate
being chemically a "salt", has a tendency to "crystallize" or to
compact into a solid structure of high resistance that settles on the
electrodes in an almost irreversible way.
In
all lead batteries, after already a year of life, especially if
subjected to prolonged discharges, long periods of downtime or for use
at excessively low or excessively high temperatures, the sulfate
process begins to block the passage of current between the plates and
then between the elements of the battery, until it gets in this way to
completely inhibit both the charge and the discharge of the battery.
CARICABATTERIE
+ DESOLFATATORE
IN UN
UNICO STRUMENTO
Our
REPOWER device autonomously recognizes, thanks to its software with
automatic diagnostic algorithm, if the battery to which it is connected
is in sulfate condition, and, only in this case, automatically starts
its particular process of desulfation at the resonance frequency of
lead sulfate crystals, disintegrating them entirely, until the battery
is fully restored. At that point, the REPOWER starts the normal
charging process.
REPOWER
GRD
230V electric grid-powered charger at
high-power (5A) with automatic desulphator
for 12V lead batteries capable
of fast charging, but, at the same time, avoiding battery stress due to
high current recharges, that cause the evaporation of the inner
electrolyte.
In
the case of sulfated battery, the duration of the recovery process and
charging depends on the condition of the battery and the extent of the
sulfation.
Extremely
versatile and easy to install thanks to:
-
230V
power plug cable
- Output
cables with red clamp (positive pole) and black clamp(negative pole) to
connect to any type of battery
- Ergonomic
handle for easy movement and positioning of the device
- Rocker
switch and 3 ultrabright LEDs for signaling anomalies / charge phases /
desulphation of the battery
TECHNICAL FEATURES
- Input
voltage range : 176-264Vac
- Maximum
power: 75W
- Conversion
efficiency : 80%
- Input
Frequency range : 47-63Hz
- 7
stages smart charger
- Overload
electronic protection
- Short
circuit electronic protection
- Overvoltage
electronic protection
- Ultrabright
Led panel
- Maximum
charging current: 5A
- Protection
degree: IP 56 + conformal coating on electronic board to prevent
oxidation
- Capacity
range of the connectable batteries : 6Ah - 120Ah
- Compatible
battery types: Lead, Lead gel, AGM
- Dimensions:
140x195x100mm176-264Vac
COD. EAN: 8319120320021
REPOWER
PVG
High-efficiency
charging regulator with automatic desulphator for 12V or 24V lead
batteries, powered by photovoltaic panel for the realization of
photovoltaic kits or modular storage systems in islanding (OFF GRID)
for energy autonomy with fast payback time: about 3 years.
In
the case of sulfate battery, the duration of the recovery process and
charging also depends on the condition of the battery and the extent of
the sulfate.
The
duration of the charging phase depends on the power of the panel
connected to the charger. On a medium-capacity car battery, the
charging time varies from half a day with a panel from 120Wp to about a
week with a 10W panel (available separately).
Extremely
versatile and easy to install thanks to:
- Wide
power range of input pluginable photovoltaic panel: 10W-315W
- Output
terminal block for connection to any type of 12V hermetic battery
(like those of antitheft systems) or open vessel (such as cars), or GEL
/ AGM, etc.
- Panel
input connection by screw terminal block
- 3
ultrabright LEDs for signaling anomalies / charge phases / desulphation
of the battery
TECHNICAL FEATURES
- Photovoltaic
panel voltage type: 12V or 24V
- Maximum
input voltage: 40V DC
- Panel
Maximum power: 315W
- Battery
Voltage: 12V or 24V
- Conversion
efficiency: 95%
- 7
steps charge profile
- Electronic
overload protection
- Electronic
short-circuit protection
- Electronic
protection against lightning surges
- Ultrabright
Led panel
- Maximum
charging current : 10A
- Degree
of protection: IP 44 and conformal coating on circuit board to prevent
oxidation
- Capacity
range of chargeable batteries: 6Ah - 120Ah
- Compatible
battery types: Lead, Lead gel, AGM
- Dimensions:
150x50x30mm
COD. EAN: 8319120320038
The
product is designed to be used only for the restoration and charging of
lead batteries, not to be used to charge/restore other types of
batteries or for applications other than those indicated in the manual.
The manufacturer denies any liability for damage to persons or
properties due to improper use of the device or otherwise different
from the one specified.
The use of our automatic desulphation charger is highly
sustainable and
environmentally friendly, as it allows the restoration and reuse of
exhausted batteries containing lead, normally intended to be disposed
of as special waste.
UNBEATABLE
PRICE:
REPOWER GRD = 104,10€ + IVA =
127€
REPOWER PVG = 78€ + IVA = 95,16€
10W POLYCRYSTALLINE PHOTOVOLTAIC PANEL
= 20,50€+iva = 25€
YOU CAN PAY BY BANK TRANSFER OR WITH CREDIT CARD -
PAYPAL
SHIPPING
ALL OVER THE WORLD
To order
it and/or ask for the price of the shipment to your country:
SUBMIT
PURCHASE REQUEST
In any case,
indicate in the message:
last name, first name, address, tax code (or VAT
number) and delivery phone number for the forwarder!
TECHNICAL SUPPORT IN JUST 24 HOURS
MONEY-BACK GUARANTEE:
If
you are not satisfied with our REPOWER devices you can request a refund
of the full amount spent on the purchase by shipping back the product
to us in its original packaging within 15 days from the purchase at our
headquarters address.